For us, the bigger the project the better. With these behemoths – we have a special division focused on coal fired power plant outages and projects.  For electrical and mechanical repairs, we have the in-house engineering and expertise to provide quality IEEE repair specifications and rebuild services.  For large field mechanical work, we are a proven partner with the major power OEMs and EPC contractors, and we are well known as a trusted sub-contractor. We can also mobilize hundreds of skilled code welders, millwrights and field machinists to complete a special outage or emergency job requirement. Solutions to keep coal fired power in motion.

Fly Ash

Fly Ash solutions to keep Coal Power in Motion

Fly ash removal and transfer is a very important process of all coal fired power plants. Fly ash is a continuous byproduct of coal combustion. Fly ash piping is subject to very abrasive conditions and requires continuous attention and monitory to determine when to remove and replace.  The Team at Laron has the resources and capabilities to fabricate and install new fly ash piping systems, when entire systems are not required to be replaced we can provide the service to make as needed repairs.

Fly Ash Transport Piping
Fly Ash Transport Piping Replacement
  • Blowers-rebuild/replace
  • Valves-rebuild/replace
  • Pipe
  • Piping structural systems & supports

Submerged Drag Chain Conveyor (SDCC)

SDCC solutions to keep Coal Power in Motion

A Submerged Drag Chain Conveyor (SDCC) is a material handling device for bottom ash that is collected from the boiler, submerged drag chain conveyors are used to cool and dewater the ash and then disperse it thru a discharge hopper where it is conveyed for disposal.  Laron has expertise in the overhaul of SDCC Units, including complete remove and replacement of seal plate panel’s, hard plate liners. Laron also has the expertise and resources to remove and replace the drive units, chains & flights.

SDCC collecting fly ash
Submerged Drag Chain Conveyor Removal
  • Fabricate Flights
  • Removal and installation of flights
  • Fabrication of wear plates
  • Remove and replace wear plates
  • Fabrication of seal plates
  • Remove and replace seal plates

Cooling Tower Piping

Piping solutions to keep Coal Power in Motion

Once the steam has passed through the turbine at these plants, it must be cooled so it can condense back to a liquid and be returned to the boiler or steam generator. This requires large piping systems for the transfer of the water, sometimes in the means of 80,000 GPM or more.  Laron can provide the expertise to design, fabricate and install these large piping systems into existing as a repair or new.

Replacing Cooling Tower Piping
Cooling Tower Piping joint
  • Piping design and fabrication
  • Excavation & installation
  • Piping liners-rubber/ceramic coating
  • Valves & operators
  • Concrete thrust blocks
  • Manhole access points

Wet Scrubber / Absorber

Wet Scrubber solutions to keep Coal Power in Motion

Absorber Expansion joint

A wet scrubber is a device to remove pollutants from a furnace flue gas or other gas streams.  In a wet scrubber, the polluted gas stream is brought in contact with the scrubbing liquid and the pollutant materials are captured in liquid droplets.  These droplets are separated from the outlet gas by means of a mist eliminator or entrainment separator.  Wet scrubbers that remove gaseous pollutants are called absorbers.  Laron can provide numerous services to support this equipment to include weld repairs as well as demo/install of components and piping.  We can also work on the ductwork and expansion joints associated with these lines.

Feedwater Heater

Feedwater Heater solutions to keep Coal Power in Motion

A feedwater heater is a power plant component used to pre-heat water delivered to a steam generating boiler. Preheating the feedwater reduces the irreversibilities involved in steam generation and therefore improves the thermodynamic efficiency of the system. This reduces plant operating costs and also helps to avoid thermal shock to the boiler metal when the feedwater is introduced back into the steam cycle.  Laron has the expertise to remove and replace Feedwater Heaters/Heat exchangers and perform repairs as required in the field or in our shops. Laron holds and maintains R, S & U stamps and has a proven quality program that insures the work will meet and exceed all applicable codes and standards.

feedwater heat exchanger
Feedwater Removal and repair
  • Remove and replace
  • Repair Heat Exchanger Shells
  • Replace /plug Tubes
  • Machine/resurface flange’s
  • Tube sheet crack repair

Boilers / Pressure Vessels

Boiler solutions to keep Coal Power in Motion

  • Superheater – Partial and Full Tube Replacements
  • Gas Baffle, Floor and Wall Replacements
  • Piping Repairs – Carbon, P22, P91
  • Desuperheater Repairs
  • Kettle IP/LP Expansion Joint Repairs
  • Reheat Bypass Valve Drip Leg Modifications
ASME Stamps
Steam Boiler Pressure vessel
Boiler ready for heat treat in oven
Boiler Repair


Valve solutions to keep Coal Power in Motion

New Valve Installation
  • High Pressure Valve Repairs and Replacements
  • Low Pressure Valve Repairs and and Replacements
  • Attemperator Repairs and Replacements
  • Steam Repair Valve and Replacement
  • Main Steam Stop Repair and Replacement
  • Hot and Cold Reheat Replacements
Valves ready for installation


Pump solutions to keep Coal Power in Motion

  • Circulating Water Pump and Head Shaft Repairs
  • Cooling Tower Pump Repairs
  • Boiler Feed Pump Repairs
  • Condensate Pump Repairs
  • Pump Installation
  • Pump Removal
  • New Pump Sales
Pump Housing Repair Shipment
Big Silver Pump
Field Services Pump Repair

Electric Motors

Motor solutions to keep Coal Power in Motion

Electric Motors in Power Plant
  • Boiler Feed Pump Motors
  • Cooling Tower Pump Motors
  • Condensate Pump Motors
  • Cooling Tower Fan Motors
  • General Plant Motors
  • Electric Motor Repairs
  • Electric Motor installations
  • New Motor Sales
Electrical Motor Rewind
900HP Finished Motors 1

Coal Services Line Card

Download our line card for a full list of our capabilities.

Contact Us to Keep Your Coal Power Industry In Motion